vim /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
BOOTPROTO=none
ONBOOT=yes
IPADDR=192.168.128.13
NETMASK=255.255.255.0
GATEWAY=192.168.128.2
DNS1=202.96.128.166
（4）配置物理网卡eth0,eth1
vim /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE=eth0
BOOTPROTO=none
MASTER=bond0
SLAVE=yes
vim /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE=eth1
BOOTPROTO=none
MASTER=bond0
SLAVE=yes
（5）修改modprobe相关设定文件
vim /etc/modprobe.d/bonding.conf
alias bond0 binding
options bond0 miimon=100 mode=0 //模式0，miimon是用来进行链路监测的,后面指定的是检查的间隔时间，单位是ms
（6）重启并测试
[root@localhost network-scripts]# ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master bond0 state UP qlen 1000
link/ether 00:0c:29:94:b5:29 brd ff:ff:ff:ff:ff:ff
3: eth1: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master bond0 state UP qlen 1000
link/ether 00:0c:29:94:b5:29 brd ff:ff:ff:ff:ff:ff
4: bond0: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP
link/ether 00:0c:29:94:b5:29 brd ff:ff:ff:ff:ff:ff
inet 192.168.128.13/24 brd 192.168.128.255 scope global bond0
inet6 fe80::20c:29ff:fe94:b529/64 scope link tentative dadfailed
valid_lft forever preferred_lft forever
查看bonud工作状况：
[root@localhost bonding]# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: load balancing (round-robin)
MII Status: up
MII Polling Interval (ms): 200
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: 00:0c:29:94:b5:29
Slave queue ID: 0
Slave Interface: eth1
MII Status: down
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: 00:0c:29:94:b5:33
Slave queue ID: 0
Linux公社的RSS地址：https://www.linuxidc.com/rssFeed.aspx